NOWATCH X: How to insert and remove discs – NOWATCH

In this article, you’ll learn how to insert and remove a disc—such as the Time Disc—from your NOWATCH case so you can safely switch between different discs.

How to insert the disc into your NOWATCH case
- How to insert a Time Disc
How to remove a disc from your NOWATCH case
Best practices for handling your disc

How to insert the disc into your NOWATCH case

Do you own a Time Disc? Jump to that section.

Place the underside of the charger over the top of your disc to activate the magnet. (A)
Lower the disc into the case, making sure it sits perfectly aligned (B).
Slide the charger sideways to disengage the magnet (C). The metal discs have a larger metallic mass, resulting in a stronger magnetic force when using the underside of the charger.

How to insert a Time Disc

Ensure the time is accurate - Double-check that the watch hands are set to the correct time. If they aren’t, follow the steps in this article to adjust the time.
Locate the notch on the Time Disc - On the edge of the time disc, there is a small notch near the top.
Align the notch with the opening in the case - Inside the watch case, you’ll see a corresponding opening/slot at the top. The notch on the Time Disc must line up with this opening for the disc to sit correctly.
Lower the Time Disc gently into the case - Once aligned, place the disc flat into the case. It should sit evenly and smoothly.
Do not force the disc - If the disc doesn’t sit flush right away, remove it, realign the notch, and try again. When properly aligned, it should fit without any pressure.
Confirm it’s fully seated - The disc should be level and secure before closing the case.

How to remove a disc from your NOWATCH case

Place the underside of the charger flat on top of the disc (A, B).
Lift the charger straight up to remove the disc from the case (C).
Slide the disc sideways to release it from the charger (D).

Best practices for handling your disc

Always keep the charger vertical when placing or removing a disc.
Do not use your fingers to change the disc.
Avoid tilting the disc during placement or removal.
Never force the Disc into the case, as this could damage both items.

place disc.png

How to insert the disc into your NOWATCH case

Related articles